Select Language:
Oguomo
Lecomtedoxa klaineana Dubard
SAPOTACEAE
Okolanguma (Gabon); Oguomo (Equatorial Guinea); Okolangouma
Mimusops klaineana Pierre ex Engl.
The tree reaches a height of more than 50 m. The bole is straight, cylindrical and tall. The trunk diameter attains 100 to 150 cm.
Lecomtedoxa klaineana occurs often in large populations, mainly in the alluvial areas.
Habitat is almost exclusively restricted to Gabon.
Occasionally vessels in diagonal and/or radial pattern. Occasionally vessels exclusively solitary (over 90%). Tangential diameter of vessel lumina 150 to 200 micras (medium). Tyloses thin walled. Tyloses common. Non-vestured pits. Vessels per mm2 6 to 10 (mediu Axial parenchyma in continuous tangential lines or fine bands. Prismatic crystals in short chains in chambered axial parenchyma cells. 5 to 8 cells per parenchyma strand. Axial parenchyma in narrow bands on lines up to 3 cells wide. Axial parenchyma bands ove 4 to 10 rays per mm (medium). Rays non-storied. Rays 1 to 4 seriate. Heterogeneous rays and/or multiseriate heterogeneous rays. Non-septate fibers. Fibers with simple to minutely bordered pits.
Unrestricted
The sapwood is white. The heartwood is red-brown, it is clearly demarcated.
3
Straight or interlocked, sometimes with an influence on further processing operations. Interlocked grain is high but not frequent.
The wood is typically medium in texture.
This species is low in luster.
Very durable to decay; without preservative treatment. This species is especially suited for all the uses with risks of permanent or long-lasting humidification. Resistant to termites attack. Heartwood is resistant to Lyctus attacks.
1
Residual stresses are reported to be absent.
Silica Content: Negligible content of silica is reported. Amounts over 0.05% may affect wood processing. Silica Value: 0.03
Nearly impossible to treat with a too much low penetration of the preservative substances.
0.85
0.98
9.4
6.4
Ease of Drying: Drying is moderately easy; some particular care is needed. Drying Defects: Risks of distortions when interlocked grain is present. Kiln Schedules: The kiln schedule has been tested.
FR-13
1.5
1501
206927
829
122
137
1207
1215
Sawing of this species requires powerful equipment.
Not suitable for veneering.
Not suitable for veneering.
Moderate blunting effect; stellited blades for sawing and carbide tools for machining are advised.
It needs powerful tools for processing. Possible difficulties caused by interlocked grain are reported. It is recommended to use special tools for cutting.
Moderately easy; tools must be cautiously sharpened.
Moderately easy; tools must be cautiously sharpened.
Moderately easy; tools must be cautiously sharpened.
Moderately easy; tools must be cautiously sharpened.
Pre-boring is necessary.
Difficult to glue because of high density.
Difficult to obtain very good results because of interlocked grain.
Can be polished without surface preparation.
Working with hand tools is difficult.
EXTERIOR GENERAL, bridges, poles, paling, stakes posts, rails, crossarms, crossties, piers, HOUSING GENERAL, beams, joists, boards, flooring, parquet, frames, CONTAINERS, truck bodies, truck flooring
Please Provide Information To View Producer Information