Select Language:
Rikio
Uapaca paludosa Aubrev.
EUPHORBIACEAE
Koondi (Sierra Leone); Rikio (Côte d`Ivoire); Bosenge (Zaire); Assam (Gabon); N'sanvi (Congo); Assam (Cameroon)
Uapaca guineensis Müll. Arg.
The tree reaches a height of 20 m. The bole is straight, with large stilt roots. The trunk diameter attains 70 cm.
Uapaca paludosa is abundant in swampy regions, sometimes found also in the savanna forests.
West Africa.
Vessels per mm2 10 to 20 (abundant). Wood diffuse porous. Occasionally vessels exclusively solitary (over 90%). Tyloses thin walled. Tangential diameter of vessel lumina 150 to 200 micras (medium). Vessel-ray pits coarse throughout the ray cell. Occasionally mu Apotracheal axial parenchyma diffuse and/or diffuse in aggregates. Paratracheal axial parenchyma scanty and/or vasicentric. Non-crystals in axial parenchyma cells. Rays storied. Rays of two distinct sizes. 4 to 10 rays per mm (medium). Larger rays more than 4 seriate. Silica bodies in the ray cells. Non-septate fibers. Fibers with simple to minutely bordered pits.
Unrestricted
The heartwood is pale-pink or pale-red, it is not clearly demarcated.
4
Straight or slightly interlocked, sometimes with an influence on further processing operations.
The wood is mostly coarse in texture.
This species is moderate in luster.
Very durable to decay; without preservative treatment. This species is especially suited for all the uses with risks of permanent or long-lasting humidification. Resistant to termites attack. Heartwood is resistant to Lyctus attacks.
1
Residual stresses are reported to be absent.
Nearly impossible to treat with a too much low penetration of the preservative substances.
0.68
0.76
Ease of Drying: Drying is moderately easy; some particular care is needed. Drying Defects: No particular risks of drying defects, subject to normal drying conditions. Kiln Schedules: The kiln schedule has been tested.
FR-11
1251
257923
651
88
107
720
805
It is easy to saw.
Not suitable for veneering.
Not suitable for veneering.
Moderate blunting effect; stellited blades for sawing and carbide tools for machining are advised.
Possible difficulties caused by interlocked grain are reported.
Easy; no particular problems.
Moderately easy; tools must be cautiously sharpened.
Moderately easy; tools must be cautiously sharpened.
Moderately easy; tools must be cautiously sharpened.
Pre-boring is necessary.
Glues well if basic gluing technical rules are followed.
Easy to perform; it gives good results.
Needs pre-coating.
No particular problems.
EXTERIOR GENERAL, rails, crossarms, crossties, HOUSING GENERAL, beams, joists, boards, flooring, parquet, steps, CONTAINERS, truck bodies, truck flooring, OTHER AND MUSICAL INSTRUMENTS, axle
Please Provide Information To View Producer Information